stereo input - options 5
user options
There are a number of user options available for the Stereo inputs. These are implemented by way of solder-pads on the back-side of the Stereo Input circuit boards (upper EQ board of the pair). There are a number of solder-pads avail- able, made up of split-circles of tinned copper. Solder is bridged (blobbed) across the 2 halves to complete the circuit and implement the desired option. For the default setting, there is already a thin copper trace that connects the two halves, completing the default connection.This existing trace MUST be cut (use an X-acto knife) before an option is implemented.
To change back to the default operation after an option was performed, remove the blobbed solder from the option solder-pads (use a solder-sucker or solder-wick). Add a blob-link across the original, default pads to replace the thin trace that was previously cut when the option was first performed.
The specified Solder-Blob (SBXX) shown in the table should be linked (by solder-bridging) to complete the circuit and implement the indicated option.The table below shows the specific SBXX for each of the 8 channels on a cir- cuitboard. Before implementing an option (by blobbing), be SURE to cut the existing thin copper trace linking the two halves of the default SB. Failure to do so will result in channel operation problems and possible circuit damage.
HPW Stereo Input
OPTIONS TABLE
“PRE” Feed For Aux Sends | | Channel Direct Out |
Post-EQ (Default) | Pre-Insert | Pre EQ | Post-EQ (Default) Pre-EQ |
Chan-1 mono | SB2 | SB1 | SB33 | SB18 | SB17 |
Chan-2 mono | SB4 | SB3 | SB34 | SB20 | SB19 |
Chan-3 mono | SB6 | SB5 | SB35 | SB22 | SB21 |
Chan-4 mono | SB8 | SB7 | SB36 | SB24 | SB23 |
| L/R | | L/R | L/R | L/R |
Chan-5 stereo SB52/SB51 | | SB50/SB9 | SB10/SB12 | SB11/SB13 |
Chan-6 stereo SB28/SB29 | | SB26/SB27 | SB14/SB16 | SB15/SB25 |
Chan-7 stereo SB40/SB41 | | SB30/SB39 | SB31/SB37 | SB32/SB38 |
Chan-8 stereo SB44/SB45 | | SB42/SB43 | SB46/SB48 | SB47/SB49 |
