matrix mix 0
matrix mix
The HPW features a 2-output Matrix section. Each Matrix can consist of a mixture of any of the 11 main mix buses: the 8 audio subgroups, Left, Right, and Mono. Each of these main buses feed the 2 matrix buses through individual Matrix Send pots, all located within the Master module, above the fader of the associated bus.These Sends were described in each of the previous sections describing the various buses.
Each Matrix mix can be used to create a unique combination of the various sub- mixes within the console. Pre- or Post-fader mixes are possible with the use of the PRE switches associated with the Matrix Send pots of each of the buses.The matrix outputs can be tailored to create the proper mix needed for each application.Typical uses are to create a vocal-rich feed for a video recording, a lower-level feed for the vestibule or waiting room, a room-independent mix for a performance video, etc.
68matrix output 1/4"TRS jack
The matrix output signal is available at this output jack.The jack is impedance-bal- anced, ground-compensated. The matrix ouputs can also be used as the source for the Alt outputs. This allows the dynamic range to be controlled and room ambi- enced to be added to the matrix signal.
Tip is +Drive, Ring is -Drive Return, Sleeve is Chassis Ground Send (Drive) impedance is 50Ω
Ring impedance is 50Ω to Audio Ground Nominal Operating Level= +4dBu
Max Output Level= +21dBu (into 2kΩ or higher)
68
