Crestron electronic CP-X2514WN, CP-X4014WN Command Control via the Network, Communication Port

7. Other Functions

7.4 Command Control via the Network

You can configure and control the projector via the network using RS-232C commands.

Communication Port

The following two ports are assigned for the command control.

TCP #23 (Network Control Port1 (Port: 23))

TCP #9715 (Network Control Port2 (Port: 9715))

NOTE • Command control is available only via the specified port above.

Command Control Settings (22)

Configure the following items from a web browser when command control is used.

Example: If the IP address of the projector is set to 192.168.1.10:

1)Enter “http://192.168.1.10/” into the address bar of the web browser, and select Projector Web Control from the selection window.

2)Enter your user name and password, and then click the [OK].

3)Click the [Port Settings] on the main menu.

4)Click the [Enable] check box to open Network Control Port1 (Port: 23) to use TCP #23. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.

5)Click the [Enable] check box to open Network Control Port2 (Port: 9715) to use TCP #9715. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.

6)Click the [Apply] button to save the settings.

62