Crestron electronic CP-X4014WN Projector Web Control Network Settings, Dhcp on, Dhcp OFF

3.Web Control

3.1Projector Web Control - Network Settings (continued)

			Item			Description
Wireless Setup				Configures the wireless LAN settings.
	Mode			Select “AD-HOC” or “Infrastructure”.
	IP Configuration			Configures network settings.
		DHCP ON		Enables DHCP.
		DHCP OFF		Disables DHCP.
			IP Address	Configures the IP address when DHCP is disabled.
			Subnet Mask	Configures the subnet mask when DHCP is disabled.
			Default	Configures the default gateway when DHCP is disabled.
			Gateway
	DNS Server Address			Configures the DNS server address.
				Select from “1” to “11” a channel to use in the AD-HOC mode.
					NOTE • Depending on the country where you are
	Ch				the channels may vary. In addition, depending on the
					country or region where you are may be required to use a
					wireless network card that confirm to the standards in the
					respective country or region.
	Encryption			Select data encryption method.
				Input the WEP key.
				Either ASCII characters or hexadecimal numbers can be
				used during WEP key input. The length of the key is defined
	WEP Key			as follows according to the WEP and character formats.
					Encryption	ASCII characters	HEX numbers
					WEP 64bit	5 characters	10 characters
					WEP 128bit	13 characters	26 characters
				Input WPA Passphrase.
	WPA Passphrase			Available number of input characters is 8 to 63. Only
				alphabets, numbers and following symbols can be used.
				!"#$%&'()*+,-./:;<=>?@ [\]^_`{}~ and space
				Select an SSID from the list.
				If you require to set your unique SSID, select [Custom], then
	SSID			set your own SSID following the rules below.
				Maximum number of input characters is 32.
				Only alphabets, numbers and following symbols can be used.
				!"#$%&'()*+,-./:;<=>?@[\]^_`{}~ and space.
(continued on next page)

20