Crestron electronic DMTH4 specs

DMTH4

Inputs to	Connect Input
Expansion	Channels 1 and 2
Outputs Tab	to Expansion Out
	Channel 1

Setting up the DMTH4

Output Source Multiplexer

The TEL output needs to be configured so that Expan- sion Final Mix 1 is sent over the telephone line for use at the remote Conference Room.

1.) Select the Out Source Tab in the DMTH4 Control Panel.

2.) Click the down arrow on the TEL Output Source selection list and select Exp Final Mix 1 from the list.

Out Source Tab

TEL Output Source

18	LECTROSONICS, INC.

Image 18

Crestron electronic quick start Setting up the DMTH4 Output Source Multiplexer

Contents

DMTH4 DMTH4 LECTROSONICS, INC Important Safety Instructions Table of Contents Introduction Unpacking the unit Controls and Features Front PanelRear Panel Cables Hardware InstallationInstalling the DM system into a rack Audio Connections Programmable Inputs Audio Outputs AUX and CodecTelephone Line Jack Programmable Outputs Codec and TEL Remote Control Ports Expansion I/O ports Installing the LecNet2 USB Driver Installing LecNet2 Software and USB DriverInstalling LecNet2 Software USB driver installation Windows XP Installation of Additional Units or LecNet 2 devices USB Driver Installation Windows Basic System Setup Initial SetupControl System Interconnections Master/Slave Configuration Using the DMTH4 Control Panel to Change Master/Slave Mode Initial Setup Hints Example Teleconferencing Setup DMTH4 Setting up the DMTH4 Main Matrix Setting up the DM1624 Main MatrixSetting up the DM1624 Expansion Matrix Setting up the DMTH4 Output Source Multiplexer Using the Touch Tone Pad Make a Telephone Call Using a Telephone SetMake a Telephone Call Using the Activity Tab Making a Phone Call Use the Type the number to dial box Use the Phone Book Connecting to the Codec Interface using the Activity Tab FCC Part 68 Compliance FCC Part 15 Compliance Installation Guide Rio Rancho, NM Limited ONE Year Warranty