CyberHome Entertainment CH-DVD 452 manual Getting Started, Powering on the unit, Inserting a disc

GETTING STARTED

1.

2.

POWER DISPLAY SETUP OPEN/CLOSE

TITLE	MENU	GOTO	PROGRAM
	PBC
ANGLE	SUBTITLE	AUDIO	MUTE

Powering on the unit

Only after all connections are complete, connect the power cord and power on the unit.

1.Plug the standard electrical plug into a wall socket or power strip.

2.The unit is now in Standby mode. Press the button “ON/STANDBY” on the front panel or the button “POWER” on your remote control to power the device on. Once the unit has been turned on, the unit will always be either ON or in standby mode.

Notes on power states

There are three power states for this unit:

•OFF - The unit is not plugged into a wall outlet. The unit draws no power.

•STANDBY - The unit is plugged into a wall outlet. The unit has not been taken out of standby by pressing either the button “ON/STANDBY” on the front panel or the button “POWER” on the remote control. The unit draws a slight amount of power to enable the remote control receiving circuit. The standby LED is glowing red.

•ON - The unit is plugged into wall outlet and either the button “ON/STAND- BY” on the front panel or the button “POWER” on the remote control has been pressed. The unit is ready to use.

3.When the screen display indicates “Loading”, the disc is read.

4.If no disc is inserted, the screen display will indicate “No disc”.

Labeling Side

Surface

Inserting a disc

1.Press the Open/Close button “K” on the front panel or on the remote con- trol to open the tray. The screen display will indicate “Open”.

2.Carefully place the disc in the tray with the label facing up. Be careful not to touch the playing surface. Hold the disc by the sides and with your fore fin- ger through the hold in the middle and insert gently into the tray. Carefully place the disc in the tray

How to insert a double-sided DVD?

Double-sided discs do not have labelling over the whole surface. The labelling for both side is in the centre of the disc. To play a side its label must be facing up.

3.Press the button “A” or “K” on the front of the device or on the remote control to close the tray. The screen display shows “Close” and then “Loading”. The information on the disc is read.

4.The inserted disc type is indicated on the screen. If the disc supports the Auto Play function, playback will begin automatically.

24