Manuals / CyberPower Systems / Computer Equipment / Network Card

CyberPower Systems Network Management Card user manual

Models: Network Management Card

1 21

Download 21 pages 32.55 Kb

Page 18

[UPS Shutdown]: Configures UPS shutdown and PC safe shutdown times.

CyberPower Network Management System

Information indicates an event that requires no action.

Warning indicates an event that does not require immediate attention, but this condition should be monitored.

Severe indicates an event that requires immediate attention.

1.Determine the severity levels and click the option buttons.

2.Click [Apply] to activate the settings.

[UPS Shutdown]: Configures UPS shutdown and PC safe shutdown times.

1.Low-Battery Duration: Time from a Low-Battery signal until load is shutdown.

2.Maximum Shutdown Time: The maximum time the UPS will wait before it shuts down in response to a turnoff command.

3.Shutdown Delay: Time the UPS will wait before it shuts down in response to a turnoff command.

Note:

In order to have the PCs connected to the UPS so that they can be shut down safely, add the IP address of the PCs into Trap Notification. (Reference to Page14.) Install “Power Panel Shutdown Service” software, and then assign the IP addresses to “Network Management Card”

16

Image 18

CyberPower Systems Network Management Card user manual UPS Shutdown Configures UPS shutdown and PC safe shutdown times

Contents

managed,monitored,and configured via SNMP Card Configuration Tool User’s Manual Network Management CardIntelligent Network Management Card allows UPS to be TABLE OF CONTENTS Overview FeaturesINTRODUCTION System RequirementsCyberPower Network Management System z CyberPower Network Management Cardz PowerPanel Shutdown Service Software and user manuals CD Unpacking7 10M Ethernet connector Definitions for LED Indicatorsz Description INSTALLATION GUIDE Step 1. Hardware InstallationFigure 2. The SNMP card setting window Figure 3. Authentication windowMethod 2 Use DOS Mode Setting CONFIGURATION GUIDE UPS Information provides the technical specifications of your UPS test will automatically stop when the batteries are low To turn off the UPS no power output from the outletsnumber between 1-99. The UPS will shut off and wait Weekly Set a specific day and time of the week for UPS shutdown 2. Click Apply to activate the settings Identification assign the system’s name, contact, and location of the system 2. Input the community functions as password, maximum of 15 characters 3. Select one option Enable or Disable Red：SevereUPS Shutdown Configures UPS shutdown and PC safe shutdown times CyberPower Network Management System 2. Select an IP Address for CyberPower Network Management Card Appendix 1 IP Address Settings of CyberPower Network Management Card1. Locate the subnet of CyberPower Network Management Card OverviewReply from 192.168.20.240 bytes=32 time10ms TTL=64 CyberPower Network Management SystemPinging 192.168.20.240 with 32 bytes of data Reply from 192.168.20.240 bytes=32 time10ms TTL=64