Manuals / CyberPower Systems / Computer Equipment / Network Card

CyberPower Systems Network Management Card user manual Configuration Guide

Models: Network Management Card

1 21

Download 21 pages 32.55 Kb

Page 9

CONFIGURATION GUIDE

CyberPower Network Management System

CONFIGURATION GUIDE

[Monitoring] menu contains [Current Status] page and [UPS Information] page

[Current Status] displays basic information of UPS current status.

	Status Field	Definition
	Input Line Voltage	Shows the current input voltage of the utility power

	Output Frequency	Displays the frequency of the utility power

	Maximum Line Voltage	Identifies the highest voltage of the utility power input to
	Maximum Line Voltage	the UPS during the previous minute of operation.
		the UPS during the previous minute of operation.
	Minimum Line Voltage	Identifies the lowest voltage of the utility power input to
	Minimum Line Voltage	the UPS during the previous minute of operation.
		the UPS during the previous minute of operation.

	Output Voltage	Shows the output voltage of the UPS.

	UPS Load	Shows the percent of battery capacity that is currently
	UPS Load	being used.
		being used.

	Internal Temperature	Displays the internal operating temperature of the UPS.

	Battery Capacity	Displays the current battery charge level.

	On Battery Time	Displays the battery time available. This display factors
	On Battery Time	in the UPS load and the Battery Capacity.
		in the UPS load and the Battery Capacity.

7

Image 9

CyberPower Systems Network Management Card user manual Configuration Guide

Contents

managed,monitored,and configured via SNMP Card Configuration Tool User’s Manual Network Management CardIntelligent Network Management Card allows UPS to be TABLE OF CONTENTS INTRODUCTION FeaturesOverview System Requirementsz PowerPanel Shutdown Service Software and user manuals CD z CyberPower Network Management CardCyberPower Network Management System Unpacking7 10M Ethernet connector Definitions for LED Indicatorsz Description Step 1. Hardware Installation INSTALLATION GUIDEFigure 3. Authentication window Figure 2. The SNMP card setting windowMethod 2 Use DOS Mode Setting CONFIGURATION GUIDE UPS Information provides the technical specifications of your UPS To turn off the UPS no power output from the outlets test will automatically stop when the batteries are lownumber between 1-99. The UPS will shut off and wait Weekly Set a specific day and time of the week for UPS shutdown 2. Click Apply to activate the settings Identification assign the system’s name, contact, and location of the system 2. Input the community functions as password, maximum of 15 characters Red：Severe 3. Select one option Enable or DisableUPS Shutdown Configures UPS shutdown and PC safe shutdown times CyberPower Network Management System 1. Locate the subnet of CyberPower Network Management Card Appendix 1 IP Address Settings of CyberPower Network Management Card2. Select an IP Address for CyberPower Network Management Card OverviewPinging 192.168.20.240 with 32 bytes of data CyberPower Network Management SystemReply from 192.168.20.240 bytes=32 time10ms TTL=64 Reply from 192.168.20.240 bytes=32 time10ms TTL=64