Manuals / CyberPower Systems / Computer Equipment / Network Card

CyberPower Systems Network Management Card number between 1-99. The UPS will shut off and wait

Models: Network Management Card

1 21

Download 21 pages 32.55 Kb

Page 12

number between 1-99. The UPS will shut off and wait

CyberPower Network Management System

[UPS Reboot] allows advanced remote control of the UPS. Select one function by clicking its button. Click [Apply] to begin the operation. Select [Cancel] to refresh the selection.

Note: The commands in [UPS Reboot] menu may change by the settings in the [UPS Schedule] menu.

	Commands	Definition
	Reboot UPS Immediately	To turn the UPS off and then on again.

	Delay 03 min(s) to Reboot	3 minutes is a default value. The user may select any
	Delay 03 min(s) to Reboot	number between 1-99. The UPS will shut off and wait
	UPS	number between 1-99. The UPS will shut off and wait
	UPS	the set amount of time before turning back on.
		the set amount of time before turning back on.

	Cancel Reboot UPS	To stop the previous command “Delay 03 min(s) to
	Cancel Reboot UPS	Reboot UPS.
		Reboot UPS.

	Turn Off UPS Immediately	To turn the UPS off immediately.

	Delay 03 min(s) to Turn Off	3 minutes is a default value. The user may select any
	Delay 03 min(s) to Turn Off	number between 1-99. The UPS will wait the set
	UPS	number between 1-99. The UPS will wait the set
	UPS	amount of time before turning OFF.
		amount of time before turning OFF.

	Cancel Turn Off UPS	To stop the previous command “Delay 03 min(s) to
	Cancel Turn Off UPS	Turn Off UPS
		Turn Off UPS

	Turn On UPS Immediately	To turn on UPS when it is turned off.

10

Image 12

CyberPower Systems Network Management Card user manual number between 1-99. The UPS will shut off and wait

Contents

managed,monitored,and configured via SNMP Card Configuration Tool User’s Manual Network Management CardIntelligent Network Management Card allows UPS to be TABLE OF CONTENTS Features INTRODUCTIONOverview System Requirementsz CyberPower Network Management Card z PowerPanel Shutdown Service Software and user manuals CDCyberPower Network Management System Unpacking7 10M Ethernet connector Definitions for LED Indicatorsz Description INSTALLATION GUIDE Step 1. Hardware InstallationFigure 2. The SNMP card setting window Figure 3. Authentication windowMethod 2 Use DOS Mode Setting CONFIGURATION GUIDE UPS Information provides the technical specifications of your UPS test will automatically stop when the batteries are low To turn off the UPS no power output from the outletsnumber between 1-99. The UPS will shut off and wait Weekly Set a specific day and time of the week for UPS shutdown 2. Click Apply to activate the settings Identification assign the system’s name, contact, and location of the system 2. Input the community functions as password, maximum of 15 characters 3. Select one option Enable or Disable Red：SevereUPS Shutdown Configures UPS shutdown and PC safe shutdown times CyberPower Network Management System Appendix 1 IP Address Settings of CyberPower Network Management Card 1. Locate the subnet of CyberPower Network Management Card2. Select an IP Address for CyberPower Network Management Card OverviewCyberPower Network Management System Pinging 192.168.20.240 with 32 bytes of dataReply from 192.168.20.240 bytes=32 time10ms TTL=64 Reply from 192.168.20.240 bytes=32 time10ms TTL=64