Remote Console And HTTPS port
Port number at which the DKVM-IP1 switch's Remote Console server and HTTPS server are listening. If left empty the default value will be used.
HTTP port
Port number at which the DKVM-IP1 switch's HTTP server is listening. If left empty the default value will be used.
Telnet port
Port number at which the DKVM-IP1 switch's Telnet server is listening. If left empty the default value will be used.
Bandwidth limitation
The maximum network traffic generated through the DKVM-IP1 switch ethernet device. Value in Kbit/s.
Enable Telnet access
Set this option to allow accessing the LARA express using the Telnet Gateway see the Section called Telnet Console ).
Disable Setup Protocol
Enable this option to exclude the DKVM-IP1 switch from the setup protocol. Setup protocol is a proprietary layer-2 MAC-based protocol to allow some configuration software to detect DKVM-IP1 devices in the network, even without IP address, and then config network related settings to DKVM-IP1 device.
LAN Interface Settings
The “Autodetect” will set the ethernet speed to the fastest possible value supported by both endpoints of the link. For example, if you use a 10M/half duplex HUB, this speed will be auto-selected. If this option does not work with some network device (HUB, switches, and routers), you can set the Ethernet interface speed of DKVM-IP1 manually to the values as supported by the network device.
Figure 6-19. Network Settings (Part 1)
