Datacom Systems VS-1200 5.3 Managem ent Connection

VS-1200 Data Acccess Switch44

NOTE: For the VS-1200 series with a Gigabit Ethernet (GE) small form-factor (SFF) port, the SFP

modules might ship already installed in your unit, or they might arrive packaged separately. See the

'Small Form-Factor Pluggable' section, 'Installing the SFP Module ,' on how to install the SFP

module.

Step 1. Connect a network or monitoring cable to an Any-to-Any port socket and the other side of

this cable to the network or monitoring tool NIC port as appropriate..

Step 2. Continue repeating Step 1. for any remaining Any-to-Any port socket you want connected

VS-1200 series.

These port sockets have integrated LEDs that display line status and line speed of each port. See

the Any-to-Any Port LED Display Code table for LED display codes.

5.3 Managem ent Connection

This section shows the MANAGEMENT port 100 Mbs Full-Duplex connection of the typical VS-

1200 configurable series hardware installation.

Step 1. Connect a network cable to the MANAGEMENT port RJ45 socket. The MANAGEMENT

port RJ45 left LED illuminates green when link has been established with the network. The

MANAGEMENT port right LED illuminates green when passing data.

The MANAGEMENT PORT is an RJ45 socket used for 100 Mbs full-duplex connection with a

straight-through LAN cable via your management LAN to a Remote Management Console which is

a standard PC using a Telnet terminal emulator software application.

Link indicates connection. The LED Display Code table deciphers the RJ45 jacks with integrated

LEDs that display line status of the MANAGEMENT PORT.