Datalogic Scanning DS4300 manual Typical Layouts, Point-to-Point

DATALOGIC DS4300

2.6 TYPICAL LAYOUTS

The following typical layouts refer to system hardware configurations. Dotted lines in the figures refer to optional hardware configurations within the particular layout.

These layouts also require the correct setup of the software configuration parameters. Complete software configuration procedures can be found in the Guide To Rapid Configuration in the WinHost Help On Line.

2.6.1 Point-to-Point

In this layout the data is transmitted to the Host on the main serial interface. Host Mode programming can be accomplished either through the main interface or the auxiliary interface.

In Local Echo communication mode, data is transmitted on the RS232 auxiliary interface independently from the main interface selection.

When On-Line Operating mode is used, the scanner is activated by an External Trigger (photoelectric sensor) when the object enters its reading zone.

		DS4300
Terminal	1	Host

3 2

1 Main serial interface

2Auxiliary serial interface (Local Echo)

3External Trigger (for On-Line mode)

Figure 2.28 - Point-to-Point layout

Installation - 2.21