Datalogic Scanning DS4300 manual Scanner cable connections to the junction box

DATALOGIC DS4300

4)After wiring the junction box and while the scanner is unplugged from the power supply, place the Scanner cable so that the rubber seal fits into the cutout in the housing of the junction box and plug the 24-pin connector into connector J1 on the PCB inside the junction box as shown in figure 2.9.

Rubber seal J1

Scanner cable

Figure 2.9 - Scanner cable connections to the junction box

5)Close the junction box using the 4 cover screws making sure the rubber seal is fitted correctly between the parts of the housing.

The junction box is now installed which completes the electrical connections for your scanning system.

If it ever becomes necessary to disconnect the scanner from the junction box, simply reverse the procedure in step 4.

Installation - 2.7