Datamax E-3202 manual

The generic Epson compatible 24- pin Windows printer driver.

1.Make sure that a roll of continuous thermal paper is installed in your E-3202.

2.With your E-3202 powered up and both lights on, press the left-hand button (ON-LINE/YES), and hold it down until both lights go off. The E-3202 is now off.

3.Hold both buttons (ON-LINE/YES and LF/FF/NO) down until both lights come back on and the printer starts to print out the PRESENT SETTINGS.

4.When the printing stops, respond to the printed message “To keep settings unchanged push the ‘NO’ key. To enter the set-up menu push the ‘YES’ key” by pressing the left-hand button (ON-LINE/YES).

5.The SET-UP MENU instructions are then printed. “To change settings: use the ‘NO’ key to move from chapter to another. Use the ‘YES’ key to enter a chapter. Within a chapter use the ‘NO’ key to move from one parameter to another. Use the ‘YES’ key to validate your parameter.”

6.Move through the communication settings making sure to set the parameters so that they match those of your PC’s communication port.

7.When you enter the Emulation chapter be sure to set it to Epson 24 pin.

8.In the Character Set chapter the default is code page 850, 12 x 24, USA. You can change it if needed.

9.In the Page chapter the default is six line per inch (6 lpi). You can change it if needed.

10.In the Media chapter you can change it to Labels. The default is continuous Paper.

11.In the Other chapter you can turn on or off the Auto Line Feed and Auto Carriage Return if needed. You can also increase or decrease the contrast of the thermal print to make it darker or lighter.

12.When finished, all of your changes will be printed. If you want to save them, press the left-hand (ON- LINE/YES) button. If you do not want to save your changes, press the right-hand (LF/FF/NO) button.

E-3202 Printer 17