Dell 1600SC manual Diskette Drive, Troubleshooting a CD Drive, Troubleshooting

following bank(s): Bank n
	OS Install Mode is enabled in the System Setup	Disable OS Install Mode in the System Setup program (see "Using
	program.	the System Setup Program" in your User's Guide).
Amount of available memory
limited to 256 MB!
	Diskette-drive or hard-drive controller cannot send	See "Troubleshooting the Diskette Drive" and "Troubleshooting
	data to the associated drive; faulty or improperly	Hard Drives" in "Troubleshooting Your System."
Attachment failed to respond	installed diskette drive or hard drive.
	Loose or improperly connected mouse or keyboard	See "Troubleshooting the Mouse" and "Troubleshooting the
	cable; faulty mouse or keyboard.	Keyboard" in "Troubleshooting Your System."
Auxiliary device failure
	Faulty CD/diskette-drive subsystem or hard-drive	See "Getting Help."
	subsystem; faulty system board.
Bad error-correction code
(ECC) on disk read
Controller has failed
	Remote BIOS firmware update attempt failed.	Retry the BIOS firmware update (see "Getting Help.").
BIOS Update Attempt Failed!
	NVRAM-clear jumper is installed.	Remove the NVRAM-clear jumper (see Figure A-2 for jumper
		location). Check the System Setup configuration settings (see
Caution! NVRAM_CLR jumper is		"Using the System Setup Program" in your User's Guide).
installed on system board.
Please run setup.
	Faulty diskette, diskette drive, CD drive, tape drive,	Replace the diskette. If the problem persists, see "Troubleshooting
	or hard drive.	the Diskette Drive," "Troubleshooting a CD Drive," "Troubleshooting
Data error		a Tape Drive," and "Troubleshooting Hard Drives" in
		"Troubleshooting Your System."
	Faulty or improperly installed memory modules.	See "Troubleshooting System Memory" in "Troubleshooting Your
		System."
Decreasing available memory
	Incorrect configuration settings in the System Setup	Run the System Setup program to correct the settings (see "Using
	program.	the System Setup Program" in your User's Guide).
Diskette drive seek failure
	Faulty or improperly installed diskette drive.	See "Troubleshooting the Diskette Drive" in "Troubleshooting Your
		System."
	Faulty or improperly inserted diskette.	Replace the diskette.
Diskette read failure
	Faulty or improperly installed diskette drive.	See "Troubleshooting the Diskette Drive" in "Troubleshooting Your
		System."
Diskette subsystem reset
failed
	Diskette write-protect feature activated.	Move the write-protect tab on the diskette to the disabled position.
Diskette write protected
	Diskette missing or improperly inserted in diskette	Reinsert or replace the diskette.
	drive.
Drive not ready
	Faulty keyboard controller; faulty system board.	See "Getting Help."
Gate A20 failure
	Operating system corrupted or improperly installed.	Reinstall the operating system.
General failure
	Incorrect configuration settings in System Setup	Run the System Setup program to correct the drive type setting
	program; improperly installed hard drive; loose	(see "Using the System Setup Program" in your User's Guide). If the
Hard disk controller failure	interface or power cable; faulty hard-drive controller	problem persists, see "Troubleshooting Hard Drives" in
	subsystem.	"Troubleshooting Your System."
	Memory module installation guidelines have not	See "Memory Module Installation Guidelines" in "Installing System
	been properly followed.	Options."
Invalid memory configuration
detected. Potential
corruption exists!
	Faulty keyboard controller; faulty system board.	See "Getting Help."
Keyboard controller failure
	Loose or improperly connected keyboard cable;	See "Troubleshooting the Keyboard" in "Troubleshooting Your
	faulty keyboard; faulty keyboard controller.	System."
Keyboard data line failure
Keyboard failure