6Align the screw holes in the Media Card Reader with the screw holes in the FlexBay slot.
7Replace the two screws that secure the Media Card Reader to the FlexBay slot.
NOTE: Ensure that the Media Card Reader is installed before the FlexBay USB cable is connected.
8Connect the FlexBay USB cable to the Media Card Reader connector on the system board. For the location of the connector, see "System Board Components" on page 8.
9Replace the front bezel (see "Replacing the Front Bezel" on page 20).
10Replace the computer cover on both the sides (see "Replacing the Computer Cover" on page 16).
11Connect your computer and devices to electrical outlets, and then turn them on.
Removing an Optical Drive
1Follow the procedures in "Before You Begin" on page 11.
2Remove the computer cover from both the sides (see "Removing the Computer Cover" on page 15).
3Remove the front bezel (see "Removing the Front Bezel" on page 19).
4Disconnect the power cable and the data cable from the back of the optical drive.
NOTE: If you are not replacing the optical drive at this time, disconnect the other end of the data cable from the system board and set it aside. You can use the data cable to install an optical drive at a later time. For the location of the SATA connectors, see "System Board Components" on page 8.
Drives
37
