Management Menu

MENU LOCATIONSelect the location of the OSD on the screen.

PROJECTION MODESelect how the image appears:

Front Projection-Desktop (the default).

Rear Projection-Desktop-- The projector reverses the image so you can project from behind a translucent screen.

Front Projection-Ceiling Mount-- The projector turns the image upside down for ceiling-mounted projection.

Rear Projection-Ceiling Mount-- The projector reverses and turns the image upside down. You can project from behind a translucent screen with a ceiling-mounted projection.

SIGNAL TYPEShow signal type RGB, YCbCr, YPbPr.

LAMP HOURDisplay the operating hours since the lamp timer reset.

LAMP RESETAfter you install a new lamp,

select Yes to reset the lamp timer.

POWER SAVINGSelect Yes to set the power saving delay period. The delay period is the amount of time you want the projector to wait without signal input. After that set time, the projector enters power saving mode and turns off the lamp. The projector turns back on when it detects an input signal or you press the power button. After two hours, the projector turns off and you need to press the power button to turn the projector on.

OSD LOCKSelect Yes to enable OSD Lock for hiding the OSD menu. (Or pressing the Menu button on control for 15 seconds), and select No to disable the OSD Lock for hiding the OSD menu. (Or pressing the Menu button on control for 15 seconds again).

RF_CH LEARNINGRefer to page 36.

ECO MODESelect On to use the projector at a lower power level (250 Watts), which may provide longer lamp life, quieter operating and dimmer luminance output on the screen. Select Off to operate at normal power level (300 Watts).

Using Your Projector

31

Page 31
Image 31
Dell 5100MP owner manual Management Menu