Dell 53-1002116-01 manual Configuring ACLs using the CEE CLI, ACL overview

	Chapter
Configuring ACLs using the CEE CLI	9

In this chapter

•ACL overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87

•Default ACL configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88

•ACL configuration guidelines and restrictions . . . . . . . . . . . . . . . . . . . . . . . . 88

•ACL configuration and management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88

ACL overview

NOTE

In the Dell Fabric OS release, only Layer 2 MAC access control lists (ACLs) are supported.

ACLs filter traffic for the Dell FCoE hardware and permit or deny incoming frames from passing through interfaces that have the ACLs applied to them. You can apply ACLs on VLANs and on Layer 2 interfaces. Each ACL is a unique collection of permit and deny statements (rules) that apply to frames. When a frame is received on an interface, the switch compares the fields in the frame against any ACLs applied to the interface to verify that the frame has the required permissions to be forwarded. The switch compares the frame, sequentially, against each rule in the ACL and either forwards the frame or drops the frame.

The switch examines ACLs associated with options configured on a given interface. As frames enter the switch on an interface, ACLs associated with all inbound options configured on that interface are examined. With MAC ACLs you can identify and filter traffic based on the MAC address, and EtherType.

The primary benefits of ACLs are as follows:

•Provide a measure of security.

•Save network resources by reducing traffic.

•Block unwanted traffic or users.

•Reduce the chance of denial of service (DOS) attacks. There are two types of MAC ACLs:

•Standard ACLs—Permit and deny traffic according to the source MAC address in the incoming frame. Use standard MAC ACLs if you only need to filter traffic based on source addresses.

•Extended ACLs—Permit and deny traffic according to the source and destination MAC addresses in the incoming frame, as well as EtherType.

Dell Converged Enhanced Ethernet Administrator’s Guide	87
53-1002116-01