VLAN configuration guidelines and restrictions

5

Additionally, there are important facts you should know about the VLAN FDB:

The VLAN FDB contains information that helps determine the forwarding of an arriving frame based on MAC address and VLAN ID data. The FDB contains both statically configured data and dynamic data that is learned by the switch.

The dynamic updating of FDB entries using learning is supported (if the port state permits).

Dynamic FDB entries are not created for multicast group addresses.

Dynamic FDB entries are aged out based on the aging time configured per Dell FCoE hardware. The aging time is between 10 and 1000000 seconds. The default is 300 seconds.

You can add static MAC address entries specifying a VLAN ID. Static entries are not aged out.

A static FDB entry overwrites an existing dynamically learned FDB entry and disables learning of the entry going forward.

NOTE

For more information on frame handling for Dell FCoE hardware, see “Layer 2 Ethernet overview” on page 3.

VLAN configuration guidelines and restrictions

Follow these VLAN configuration guidelines and restrictions when configuring VLANs:

Make sure your converged mode interface is not configured to classify untagged packets to the same VLAN as the incoming VLAN-tagged packets. By configuring a converged interface to classify untagged packets (by using classifiers or the default port VLAN ID) to the same VLAN as VLAN-tagged packets coming into the interface, the FCoE hardware sends out untagged packets to the CNA. These packets may be dropped, disrupting communications.

In an active topology, MAC addresses can be learned, per VLAN, using Independent VLAN Learning (IVL) only.

A MAC address ACL always overrides a static MAC address entry. In this case, the MAC address is the forwarding address and the forwarding entry can be overwritten by the ACL.

The Dell CEE switch supports Ethernet DIX frames and 802.2 LLC SNAP encapsulated frames only.

Default VLAN configuration

Table 7 lists the default VLAN configuration.

TABLE 7

Default VLAN configuration

 

 

 

 

Parameter

 

Default setting

 

 

 

Default VLAN

 

VLAN 1

 

 

Interface VLAN assignment

All interfaces assigned to VLAN 1

 

 

 

VLAN state

 

Active

 

 

 

MTU size

 

2500 bytes

 

 

Port assignment

VLAN 4095

 

 

 

Dell Converged Enhanced Ethernet Administrator’s Guide

33

53-1002116-01

 

Page 51
Image 51
Dell 53-1002116-01 manual Vlan configuration guidelines and restrictions, Default Vlan configuration