Dell 53-1002116-01 manual Using the CEE CLI, Management Tools, CEE Command Line Interface

	Chapter
Using the CEE CLI	2

In this chapter

•Management Tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

•CEE Command Line Interface. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

•Internal and external 10 Gbps Ethernet interfaces syntax. . . . . . . . . . . . . . 20

Management Tools

The Dell FCoE hardware runs traditional Fabric OS (FOS) software and can be managed using the same tools traditionally used for SAN management. Using the FOS Command Line Interface (CLI), administrators have access to all commands and utilities common to other Dell switches. In addition, Fabric OS software on the Dell FCoE hardware enables Dell Web Tools to support the following features for configuring and managing a Converged Ethernet Network:

•CEE interface display and configuration

•FCoE trunk display and configuration

•CEE configuration including link aggregation (LACP), Virtual LANs (VLANs), Quality of Service (QoS), and LLDP (Link Layer Discovery Protocol)/ DCBX protocol (Data Center Bridging eXchange)

•FCoE login groups

CEE Command Line Interface

The Dell FCoE hardware introduces a new CLI designed to support the management of CEE and Layer 2 Ethernet switching functionality. The CEE CLI uses an industry-standard hierarchical shell familiar to Ethernet/IP networking administrators.

All conventional port-related Fabric OS CLI commands are only applicable to Fibre Channel. These commands have no knowledge of the Ethernet ports. The CEE features and CEE ports can only be configured through the CEE CLI interface which is accessed by entering the cmsh command from the Fabric OS shell.

The system starts up with the default Fabric OS configuration and the CEE startup configuration. After logging in you are in the Fabric OS shell. For information on accessing the CEE commands from the Fabric OS shell, see “Accessing the CEE CLI from the Fabric OS shell” on page 15.

Some Fabric OS commands are available in the CEE shell. Enter the fos ? command at the CEE CLI Privileged EXEC mode command prompt to view the available Fabric OS commands. The traditional Fabric OS command help found in the Fabric OS shell is not available through the CEE shell.

Dell Converged Enhanced Ethernet Administrator’s Guide	13
53-1002116-01