Dell 53-1002116-01 manual Default ACL configuration, ACL configuration guidelines and restrictions

9 Default ACL configuration

MAC ACLs are supported on the following interface types:

•Physical interfaces

•Logical interfaces (LAGs)

•VLANs

Default ACL configuration

Table 15 lists the default ACL configuration.

TABLE 15	Default MAC ACL configuration
Parameter	Default setting
MAC ACLs	By default, no MAC ACLs are configured.

ACL configuration guidelines and restrictions

Follow these ACL configuration guidelines and restrictions when configuring ACLs:

•The order of the rules in an ACL is critical. The first rule that matches the traffic stops further processing of the frames.

•Standard ACLs and extended ACLs cannot have the same name.

ACL configuration and management

You need to enter either the copy running-configstartup-configcommand or the write memory command to save your configuration changes to Flash so that they are not lost if there is a system reload or power outage.

NOTE

To see the minimum configuration required to enable FCoE on the Dell M8428-k switch, refer to Chapter 3, “Initial FCoE and CEE Configuration”.

Creating a standard MAC ACL and adding rules

NOTE

You can use the resequence command to change all the sequence numbers assigned to the rules in a MAC ACL. For detailed information, see “Reordering the sequence numbers in a MAC ACL” on page 90.

To create a standard MAC ACL and add rules, perform the following steps from Privileged EXEC mode.

1.Enter the configure terminal command to access global configuration mode.

2.Create a standard MAC ACL and enter ACL configuration mode.

88	Dell Converged Enhanced Ethernet Administrator’s Guide
	53-1002116-01