Dell 53-1002116-01 Defining a priority-table map, Applying a CEE provisioning map to an interface

10 Converged Enhanced Ethernet map configuration

Defining a priority-table map

To define a priority-table map, perform the following steps from Privileged EXEC mode. 1. Enter global configuration mode.

switch#configure terminal

2. Specify the name of the CEE map to define. In this example ‘test’ is used.

switch(config)#cee-map test

3. Define the map.

switch(config-ceemap)#priority-table 1 1 1 0 1 1 1 15.0

4. Enter the copy command to save the running-config file to the startup-config file.

switch#copy running-config startup-config

Applying a CEE provisioning map to an interface

To apply a CEE provisioning map, perform the following steps from Privileged EXEC mode. 1. Enter global configuration mode.

switch#configure terminal

2. Specify the 10-gigabit Ethernet interface. In this example, 0/2 is used.

switch(config)#interface intengigabitethernet 0/2

3. Apply the CEE map on the interface.

switch(conf-if-te-0/2)#cee default

The following example applies the CEE provisioning map on an interface.

switch:root>cmsh switch>enable switch#configure terminal

Enter configuration commands, one per line. End with CNTL/Z. switch(config)#interface intengigabitethernet 0/2 switch(conf-if-te-0/2)#cee default switch(conf-if-te-0/2)#exit

switch(config)#end

4. Enter the copy command to save the running-config file to the startup-config file.

switch#copy running-config startup-config

Verifying the CEE maps

To verify the CEE map, perform the following steps from Privileged EXEC mode. 1. Enter global configuration mode.

switch#configure terminal

2. Verify the CEE map provisioning for a specified name.

switch(config)#show cee maps default

110	Dell Converged Enhanced Ethernet Administrator’s Guide
	53-1002116-01