Dell 5324 manual 250

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

•groupname — The name of the group to which the user belongs.(Range: Up to 30 characters)

•remote engineid-string— Specifies the engine ID of remote SNMP entity to which the user belongs. The engine ID is concatenated hexadecimal string. Each byte in hexadecimal character strings is two hexadecimal digits. Each byte can be separated by a period or colon.(Range: 5 - 32 characters)

•auth-md5—The HMAC-MD5-96 authentication level. The user should enter password.

•auth-sha—The HMAC-SHA-96 authentication level. The user should enter password.

•password — A password (not to exceed 32 characters) for authentication and generation of DES key for privacy.(Range: Up to 30 characters)

•auth-md5-key— The HMAC-MD5-96 authentication level. The user should enter authentication and privacy keys.

•md5-des-keys— Concatenated hexadecimal string of the MD5 key (MSB) and the privacy key (LSB). If authentication is only required you should enter 16 bytes, if authentication and privacy are required you should enter 32 bytes. Each byte in hexadecimal character strings is two hexadecimal digits. Each byte can be separated by a period or colon. (Range: 16 - 32 characters)

•auth-sha-key—The HMAC-SHA-96 authentication level. The user should enter authentication and privacy keys.

•sha-des-keys— Concatenated hexadecimal string of the SHA key (MSB) and the privacy key (LSB). If authentication is only required you should enter 20 bytes, if authentication and privacy are required you should enter 36 bytes. Each byte in hexadecimal character strings is two hexadecimal digits. Each byte can be separated by a period or colon. (Range: 20 - 36 characters)

Default configuration

No group entry exists.

Command Mode

Global configuration

User Guidelines

•If auth-md5or auth-shais specified, both authentication and privacy are enabled for the user.

When you enter a show running-configcommand, you will not see a line for this user. To see if this user has been added to the configuration, type the show snmp user command.

An SNMP EngineID should be defined in order to add users to the device.

Changing or removing the value of snmpEngineID deletes the SNMPv3 users database.

250

SNMP Commands