Administrator and Command Reference

Table 3-9 lists LCD error messages that the system detects when starting.

; (#:

-	$

Add at least xMB more memory	x—The amount of memory you need to
	add to the system. The system has too lit-
	tle memory for the amount of disk space
	installed.

Cannot initialize labels	When it tries to create a new file system,
	the system cannot initialize the disk
	labels.

Cannot read labels	This error occurs only when the filer tries
	to initialize a new file system. The mes-
	sage indicates that the filer has a problem
	reading disk labels it wrote to the disks.
	This error occurs because

The system fails to read the size of a disk.

The written disk labels were not valid.

Can’t open /etc/rc	The /etc/rc file is corrupted. Run setup by
	entering setup at the hostname>
	prompt.
	The setup program prompts you to enter
	the necessary system configuration infor-
	mation. For more information about the
	filer setup program, refer to the Dell
	PowerVault 720N, 740N, and 760N System
	Administrator and Command Reference
	Guide.

Dirty shutdown in degraded	The file system might be inconsistent
mode	because you did not shut down the sys-
	tem cleanly when it was in degraded
	mode.

Configuration exceeds max PCI	Memory space for mapping in PCI cards
space	has been exhausted.
	Make sure that all expansion cards in the
	filer are supported cards.

Disk labels scrambled!	The disk labels are corrupted.

Dell 760N, 720N, 740N manual Administrator and Command Reference