Nostic messages up to 32 characters

Figure 1-2 shows the standard features that you can see with the front bezel removed.

LCD

Reset	Diskette drive
button

Table 1-2 describes the features that you can see after the front bezel is removed.



Reset Button	This button is behind the front bezel so
	that you cannot reset the filer inadvert-
	ently. It enables you to reset the filer in
	those rare cases when the system fails
	or you upgrade the software.
	To reset the filer, remove the front bezel
	and push the reset button, located
	below the power LED.

Diskette Drive	This drive enables you to boot the sys-
	tem from a diskette when the system
	fails to start from the hard disk. You also
	use this drive to run diagnostics using
	the diagnostics diskette.

LCD (Liquid Crystal Display)	The LCD displays status, error, and diag-
	nostic messages up to 32 characters
	long.
	The LCD messages are described in the
	section, “LCD messages,” in Chapter 3.

Introduction 1-3