Dell Area-51 ALX manual To replace a card

1

	2
	3
1	PCI Express x16 card	3 PCI Express x16 connector
2	retention mechanism

NOTE: If you are not replacing a card, install a filler bracket in the empty card-slot opening.

To replace a card:

1.Remove the filler bracket to create a card-slot opening (if applicable).

2.For information on configuring, customizing, and making internal connections on the card, see the documentation that shipped with the card.

CHAPTER 5: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS

3.Align the card with the connector on the system board.

4.Place the card in the connector and press down firmly. Ensure that the card is firmly seated in the connector.

If you are installing the PCI Express card into the x16 card connector, gently push the retention mechanism and place the card in the connector.

5.Connect any cables that should be attached to the card (if applicable).

6.Push the shroud to snap it into place.

7.Close the side panel (see “Opening and Closing the Side Panel“ on page 38).

8.Connect the computer and devices to electrical outlets, and then turn them on.

045/045