w w w . d e l l . c o m s u p p o r t . d e l l . c o m

NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure.

1Remove the hard drive.

2Remove the keyboard.

NOTICE: You must remove the display assembly before you remove the palmrest assembly; the display assembly hinges pass through the back of the palmrest assembly.

3Remove the display hinge cover and display assembly.

4Turn the computer over and remove the three M2.5 x 12-mm screws that are labeled with a "circle P."

5Remove the two M2 x 3-mm screws that are located in the hard drive bay labeled with a "circle P."

6Turn the computer over, and remove the three M2 x 3-mm screws that secure the palmrest to the bottom case assembly.

Remove the two M2 x 3-mm screws that are located on the back edge of the bottom case assembly, underneath the display assembly.

Remove the M2 x 3-mm screw located underneath the keyboard, on the right side of the bottom case assembly, next to the microprocessor thermal cooling assembly.

7Pull up on the pull tab that is attached to the palmrest flex cable connector to remove it from the touch pad connector on the system board assembly.

42Removing and Replacing Parts

Page 42
Image 42
Dell C600 service manual Removing and Replacing Parts