Beep Codes and System Messages C-7
System
battery is
dead -
Replace and
run SETUP
The CMOS clock battery
indicator shows the bat-
tery is dead.
Replace the battery, and run the
system setup program to recon-
figure the system.
System BIOS
shadowed The system BIOS has
been copied to shadow
RAM.
No action is necessary.
System cache
error - cache
disabled
RAM cache failed the
BIOS test; the BIOS has
disabled the cache.
If you receive this message after
making changes in the system
setup program, enter the pro-
gram and restore the original
value(s).
If the problem persists, refer to
Chapter 8, “Getting Help,” for
instructions on obtaining technical
assistance.
System CMOS
checksum
bad - run
SETUP
System CMOS has been
corrupted or modified
incorrectly, perhaps by
an application that
changes data stored in
CMOS.
Run the system setup program
and reconfigure the system by
either reverting to the default
values or making your own
selections.
System RAM
failed at
offset:
nnnn
System RAM failed at
offset
nnnn
in the 64-KB
block in which the error
was detected.
If you receive this message after
making changes in the system
setup program, enter the pro-
gram and restore the original
value(s).
If the problem persists, refer to
Chapter 8, “Getting Help,” for
instructions on obtaining technical
assistance.
System timer
error The timer test failed. If you receive this message after
making changes in the system
setup program, enter the pro-
gram and restore the original
value(s).
If the problem persists, refer to
Chapter 8, “Getting Help,” for
instructions on obtaining technical
assistance.
7DEOH&6\VWHP0HVVDJHVFRQWLQXHG
0HVVDJH 3RVVLEOH&DXVH &RUUHFWLYH$FWLRQ
NOTE: The Glossary in the
Online Guide
defines abbreviations and acronyms.