Control Panel
Removing the Control Panel
1Turn off the enclosure and host server.
2Disconnect all the power cables connected to the enclosure.
3Remove the hard drives from:
–slots 0 to 2 in PowerVault MD1200
–slots 0 to 5 in PowerVault MD1220
See "Removing a Hard Drive" on page 31.
NOTE: Mark each hard drive with it’s slot position as you remove it.
4Slide the control panel out of the chassis after:
–Pushing the release tab toward the front of the enclosure in PowerVault MD1200. See Figure
–Pulling the release pin toward the front of the enclosure in PowerVault MD1220. See Figure
42
Installing Enclosure Components
