Dell E6400 XFR service manual Removing the Palm Rest

Dell™ Latitude™ E6400 XFR Service Manual

7.Install the display gaskets using your plastic scribe. Use a push motion altering sides on an individual gasket until the gasket is completely inserted into the chassis bridge.

8.Route the display cable and wireless (WLAN, WWAN, and WPAN) cables. Fit the cables under each tab in their respective routing channel.

9.Depending on the cards in your computer configuration, connect the antenna cables to their respective card: For WWAN, see Replacing a WWAN Card. For WPAN, see Replacing a WPAN (UWB/BT) Card.

For WLAN, see Replacing the WLAN/WiMax Card.

Place any unused antenna cables in the base assembly cable holders next to the card slot.

10.If the system has the optional USB cable in the LCD assembly, reconnect the cable to the I/O board.

11.Connect the display cable to the display cable connector on the system board.

12.Connect the RF Passthru antenna cables (see Replacing the RF Passthru Board).

13.Replace the LCD cable channel covers (see Replacing the LCD Cable Channel Covers).

14.Replace the bottom access panel (see Replacing the Bottom Access Panel).

15.Follow the procedures in After Working on Your Computer.

21 Palm Rest

21.1 Removing the Palm Rest

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

1.Follow the instructions in Before Working on Your Computer.

2.Remove the bottom access panel (see Removing the Bottom Access Panel).

3.Remove the display assembly (see Removing the Display Assembly).

4.Remove the keyboard (see Removing the Keyboard).

5.Remove the two M2.5 x 5-mm screws on each cable access panel. Remove the two cable access panels from the palm rest.

Page 46