Dell
™
Latitude™ E6400 XFR Service Manual
Page 63
35.2 Replacing the Stylus
1. Pinch the end of the tether loop to a point.
2. Place the tether loop, pointed end first, through the tether anchor at the edge of the system.
3. Run the stylus and tether through the tether loop.
4. Once the stylus and tether are completely through the tether loop, pull the stylus to secure the tether loop
onto the tether anchor.
5. Insert stylus in stylus bay of the handle
6. Follow the procedures in After Working on Your Computer.
36.1 Removing the Handle
CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Follow the procedures in Before Working on Your Computer.
2. Remove the six M2.5 x 8-mm screws from the front of the palm rest.
3. Turn the system over and remove the four M2.5 x 8-mm palm rest retainer screws.
4. Place a scribe against the handle socket on the side, press in 1 inch and rotate to the front to lift the palm rest
area slightly.