Back to Contents Page

Memory

Dell™ OptiPlex™ FX160/160 Service Manual

Removing a Memory Module

Replacing a Memory Module

Your computer supports one or two memory modules.

NOTE: Your computer supports non-ECC, 667 MHz or 800 MHz, DDR2 SDRAM only. It supports memory module sizes of 512 MB (for embedded Linux operating systems only), 1 GB, and 2 GB. When 800 MHz memory is installed, your computer operates at 667 MHz. See support.dell.com for more information.

Removing a Memory Module

1.Perform the procedure in Before Working on Your Computer.

2.Carefully spread apart the securing clips on each end of the memory module connector until the memory module pops out.

1 DIMM_1 memory connector

2 DIMM_2 memory

 

connector

3securing clip (two per connector, white – DIMM_1, black – DIMM_2)

3.Remove the memory module from the connector.

Replacing a Memory Module

NOTE: If your computer contains a single memory module, it must be inserted in the DIMM_1 memory connector. The DIMM_1 connector has white securing clips.

1. Place the module in the memory module connector, and align the notch in the module with the tab on the connector.

NOTE: If the memory module is not installed properly, the computer may not boot. No error message indicates this failure.

2. Press down on the module until the securing clips lock into place. If the clips do not click into place, remove the module and reinstall it.

.

1

DIMM_1 memory

2

tab in memory connector

Page 22
Image 22
Dell FX160 manual Removing a Memory Module, Replacing a Memory Module