Dell R720XD owner manual Installing The Internal Dual SD Module

Figure 45. Removing and Installing the Internal Dual SD Module
1.	blue pull tab	2.	SD card 1
3.	SD card 2	4.	dual SD module

5.connector on the system board

Installing The Internal Dual SD Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2.Open the system.

3.Remove the expansion-card riser cage 3 and any card(s) installed in the riser.

4.Locate the J_IDSDM connector on the system board.

5.Align the connectors on the system board and the dual SD module.

6.Holding the tab, push the dual SD module until it is firmly seated on the system board.

7.Replace the expansion-card riser 1 and if applicable, replace the card(s) in the riser.

8.Close the system.

9.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

79