Dell R720XD owner manual Installing The System Board

Figure 77. Removing and Installing the System Board
1.	system board	2.	system-board holder
3.	release pin	4.	support bracket (present on certain systems
			only)

WARNING: The heat sink and processor are hot to the touch for some time after the system has been powered down. Allow the heat sink and processor to cool before handling them.

8.Remove heat sink(s)/heat-sink blank(s) and processors(s)/processor blank(s).

9.Remove memory modules and memory module blanks.

10.Remove network daughter card.

Installing The System Board

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.Unpack the new system board assembly.

2.Transfer the following components to the new system board:

a.heat sink(s)/heat-sink blank(s) and processors(s)/processor blank(s)

b.memory modules and memory module blanks

c.network daughter card

CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components.

CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.

3.Hold the touch points and lower the system board into the chassis.

121