Figure 26. Removing and Installing the Optical Drive
1. | optical drive | 2. power/data cable |
3. | release tab |
|
Installing The Optical Drive
NOTE: This procedure applies only to PowerEdge R720.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.If installed, remove the front bezel.
2.Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
3.Open the system.
4.To remove the optical drive blank, press the blue release tab at the back of the blank and push the blank out of the system.
5.Align the optical drive with the optical drive slot on the front of chassis.
6.Slide the optical drive into the slot until the latch snaps into place.
7.Connect the power/data cable to the back of the drive.
8.Route the power/data cable along the inside left wall of the chassis.
9.Connect the power/data cable to the connectors on the system board.
10.Install the
11.Close the system.
12.If applicable, install the front bezel.
13.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
55
