Installing The Integrated Storage Controller Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2.Open the system.
3.Remove the cooling shroud.
4.Remove the
5.Align one end of the card with the card holder on the system board.
6.Lower the other end of the card into the
7.Press the card down until it is fully seated.
When the card is fully seated, the release levers snap over the edge of the card.
8.Replace the
9.Replace the cooling shroud.
10.Close the system.
11.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Network Daughter Card
Removing The Network Daughter Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2.Open the system.
3.If installed, remove expansion card(s) from the
4.Using a #2 Phillips screwdriver, loosen the two captive screws that secure the network daughter card to the system board.
5.Hold the network daughter card by the edges on either side of the touch point and lift to remove it from the connector on the system board.
6.Slide the network daughter card away from the back of the system until the NIC connectors are clear of the slot in the back panel.
7.Lift the network daughter card out of the chassis.
82
