Dell R720XD owner manual Removing The vFlash Media Unit

Figure 43. Removing and Installing the SD vFlash Card

1. SD vFlash card 2. SD vFlash card slot

3.To install the SD vFlash card, with the label side facing up, insert the contact-pin end of the SD card into the card slot on the module.

NOTE: The slot is keyed to ensure correct insertion of the card.

4.Press inward on the card to lock it into the slot.

Removing The vFlash Media Unit

NOTE: This procedure applies only to PowerEdge R720xd.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2.Open the system.

3.Remove the screw securing the vFlash media unit to the chassis.

4.Remove the cable from the vFlash media unit and the backplane.

5.Slide the vFlash media unit toward front of chassis and lift it out of the system.

6.Close the system.

7.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

76