w w w . d e l l . c o m s u p p o r t . d e l l . c o m

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

•This device may not cause harmful interference.

•This device must accept any interference received, including interference that may cause undesired operation.

Class A

This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s instruction manual, may cause harmful interference with radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case you will be required to correct the interference at your own expense.

Class B

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s instruction manual, may cause interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/television technician for help.

16

Dell PowerConnect RPS-600 Setup Guide

Page 16 Page 18
Page 17
Image 17
Dell 2T227 setup guide Dell PowerConnect RPS-600 Setup Guide
Page 16 Page 18

2T227, RPS-600 specifications

The Dell RPS-600, model 2T227, is a robust and efficient power supply solution designed specifically for Dell's PowerEdge servers. This unit is particularly favored in configurations where high availability and redundancy are critical components of the system architecture. The RPS-600 is known for its reliability and performance, making it an ideal choice for businesses that require consistent uptime.

One of the standout features of the RPS-600 is its impressive power output capacity of 600 watts, which provides ample energy supply for even the most demanding server configurations. This power supply unit operates efficiently, ensuring that the servers run optimally while consuming minimal energy. The high efficiency is supported by a design that meets the 80 PLUS certification, indicating that it operates at least 80% efficiency at various loads, thus minimizing wasted energy and reducing operational costs.

The RPS-600 is designed to work with Dell's redundant power supplies, allowing for seamless failover in case of any power supply failure. This feature is essential for enterprises that cannot afford any system downtime. The unit is equipped with a hot-swappable design, allowing IT administrators to replace the power unit without having to shut down the server, ensuring continuous operation during maintenance or upgrades.

In terms of connectivity, the RPS-600 features a standard input connector that ensures compatibility with a wide range of Dell servers. The power supply is also designed with built-in protections that safeguard against common electrical issues such as overvoltage, overcurrent, and short circuits. This enhances both the reliability and the longevity of the connected hardware.

Furthermore, the Dell RPS-600 supports a wide input voltage range, making it flexible for use in various environments and geographic locations. Its compact form factor allows it to fit seamlessly into server racks, maximizing space utilization while ensuring optimal airflow and cooling.

Overall, the Dell RPS-600,2T227, embodies advanced features and technologies that cater to the demands of modern data centers and businesses. With its focus on efficiency, reliability, and ease of maintenance, it remains a top choice for organizations looking to enhance their server's performance while ensuring maximum uptime and minimal operational costs.
Top Page Image Contents