TABLE TO SAW
1.Align the two table studs (A) Fig. 27, on the bottom of the table, with the two holes in the trunnion assemblies (B). Place table on trunnion assemblies.
NOTE: MAKE SURE THE SLOT (C) FIG. 27, IN THE TABLE IS FACING AWAY FROM THE ARM (D).
2.Thread a 7/16" jam nut (C) Fig. 28 onto each table stud and tighten securely.
3.Place table handles (H) on each stud as shown in Fig. 29. NOTE: MAKE SURE THE TABLE HANDLES
ARE POSITIONED AS SHOWN IN FIG. 29.
4.Thread a 7/16" locknut (D) Fig. 30, onto each stud, up to the table handle and then loosen a 1/2 turn.
C
A |
|
|
| D | ||
|
|
|
| A | ||
|
|
|
|
| ||
B |
|
|
|
| B | |
|
|
|
| |||
|
| |||||
Fig. 27
C
C
Fig. 28
H
H
Fig. 29
D
D
Fig. 30
14
