OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND
STOPPING SAW
The power switch is located on the left side of the machine. To turn the machine “ON”, push the green start button (A) Fig. 41. To turn the machine “OFF”, push the red stop button (B).
A
B
Fig. 41
LOCKING SWITCH IN THE “OFF” POSITION
IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use, using a padlock (C) Fig. 42 with a 3/16" diameter shackle.
TILTING THE TABLE
1.
DISCONNECT MACHINE FROM POWER SOURCE.
2.The table on the band saw can be tilted 45 degrees to the right and 9 degrees to the left. To tilt the table to the right, loosen the two clamp handles (A) Fig. 43, tilt the table to the desired angle as shown on the scale (D) Figs. 43 and 44, and tighten two locking handles (A) Fig.
3.To tilt the table to the left, loosen the two locking handles (A) Fig. 43, and tilt the table to the right until the table stops (B) Fig. 44 can be accessed. Rotate the table stop (B) Fig. 44, and tilt the table to the left. Tighten the two locking handles (A) Fig. 43.
C
Fig. 42
D
A
A
Fig. 43
B
D
Fig. 44
17
