ON / OFF SWITCH
TO STAND
1.Remove the two outer hex nuts and lock washers (A) Fig. 34 from the switch box (B).
2.Insert two screws (C) Fig. 35, located on back of switch box, into two holes (D) located in the band saw arm.
3.Use the two nuts and lockwashers (L) Fig. 36, removed in STEP 1, to fasten the switch box to the bandsaw arm.
4.Remove the screw and cable clamp (E) Fig. 37 from the lower arm of the band saw.
5.Insert the switch cord and power cord (F) Fig. 37 into the clamp (E), and fasten to the bandsaw.
A B
A
Fig. 34
D
C
Fig. 35
L
Fig. 36
F
E
Fig. 37
16
