Delta 28-348 instruction manual Assembly, Motor Bracket To Cabinet, Motor to Motor Bracket

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

MOTOR BRACKET

TO CABINET

1.Place the cabinet on its side as shown in Fig. 6.

2.Align the two holes in the motor bracket (A) Fig. 7, with the two holes in the cabinet. NOTE: ATTACH

MOTOR BRACKETS TO HOLES #2 AND 4 IN FRONT CABINET FLANGE (D) FIG. 6, AND HOLES #4 AND 6 IN REAR CABINET FLANGE (E).

NOTE: MAKE SURE THE SLOTS (C) FIG. 7, IN THE MOTOR BRACKET (A), ARE POSITIONED CLOSER TO THE OPENING OF THE CABINET (D) THAN THE BACK PANEL (E) OF THE CABINET.

3.Insert 5/16-18x3/4" carriage head bolts through the holes in the motor brackets (A) Fig. 7, and the holes in the cabinet.

4.Thread 5/16-18 flange hex nuts onto the screws and tighten securely.

1 2 3 4 5 6

E

1 2 3 4

D

Fig. 6

E

D C C A

Fig. 7

MOTOR TO

MOTOR BRACKET

1.Place the motor (B) Fig. 8, on the motor brackets (A). Align the holes in the motor mounting plate with the holes on the motor brackets.

2.Insert 5/16-18x3/4" carriage head bolts through the holes in the motor brackets and the holes in the motor mounting plate.

3.Thread 5/16-18 flange hex nuts on to screws.

NOTE: DO NOT COMPLETELY TIGHTEN THE HARDWARE AT THIS TIME.

B

A

Fig. 8

4. Place cabinet on its base as shown in Fig. 9.

Fig. 9

9