Delta Electronics RTU-DNET manual DeviceNet I/O Mapping Data

DeviceNet Remote I/O Communication Module RTU-DNET

Attribute	Access	Name	Range	Default	Explanation
ID	rule
61	Get/Set	Output data	N/A	N/A	Length of output data of special
		length for
					module 6
		module 6
		Start CR for			Start CR for the output data of special
62	Get/Set	module 7	N/A	N/A
					module 7
		output data
63	Get/Set	Output data	N/A	N/A	Length of output data of special
		length for
					module 7
		module 7
64	Get/Set	Start CR for	N/A	N/A	Start CR for the output data of special
		module 8
					module 8
		output data
65	Get/Set	Output data	N/A	N/A	Length of output data of special
		length for
					module 8
		module 8

„Class 0x9C – Extension module parameter object Class attribute

Attribute ID	Access rule	Name	Data type
1	Get	Revision	UINT
2	Get	MaxInstance	UINT

Instance 1 ~ 8 (CR for the 1st ~ 8th special module)

Attribute ID	Access rule	Name	Data type
1	Get	Content in CR#0	UINT
2	Get/Set	Content in CR#1	UINT
3	Get/Set	Content in CR#2	UINT
…	…	…	UINT
9	Get/Set	Content in CR#8	UINT
10	Get/Set	Content in CR#9	UINT
…	…	…	UINT

Note:

zWhen you modify the content in CR of the special module through DeviceNet, please read out the content again (Get_Attribute_Single) after the modification and confirm that it has been modified successfully.

zThe content in some CRs of the special module cannot be modified. Therefore, please pay attention to these parameters when you are modifying them.

4.3DeviceNet I/O Mapping Data

1.Control word and status word in RTU-DNET

„Control word

bit	Status value	Explanation
0	0	Setting RTU-DNET to STOP mode
	1	Setting RTU-DNET to RUN mode
1	0/1	Reserved

14 DVP-PLC Application Manual