Delta Electronics manual How to Construct a DeviceNet Network Using RTU-DNET, Dvpdnet-Sl

DeviceNet Remote I/O Communication Module RTU-DNET

5 How to Construct a DeviceNet Network Using RTU-DNET

In this section, we will explain how to configure RTU-DNET and the I/O mapping relation between RTU-DNET and DVPDNET-SL by an application example.

5.1How to Construct DeviceNet by RTU-DNET

1.The DeviceNet network

DVPDNET-SL

DVP28SV

DVPDNETDVP28SV

DeviceNet

network configuration tool

RUN

STOP

Master

TE

ND

U-

TR

DeviceNet

VD P- 80 TS

DVP-16SP

DA4 0-P VD CT4 0-P VD TP4 0-P DV

DVP-02DA

2.	Set up DVPDNET-SL and RTU-DNET according to the table below.
		Module	Node address	Baud rate
		DVPDNET-SL	1	500 kbps
		RTU-DNET	2	500 kbps
3.	Pleae check if all Slim DI/DO extension units, special modules and RTU-DNET are working normally, if the
	wiring of the entire network is correct, and if the power supply in DeviceNet is normal.
5.2 How to Configure Network by DeviceNet Network Configuration Tool
1.	Configuration of RTU-DNET
	(1) Open DeviceNetBuilder software, as below:

22 DVP-PLC Application Manual