Denon 4010UDCI About the Remote Control Unit, Inserting the Batteries, Operating Range of the Remote Control Unit, Remote Control Settings (Remote Control Side)

ENGLISH

Getting	About the Remote Control Unit
	Inserting the Batteries
Started
	q Remove the remote	control w Set three R6/AA batteries in
Connections	unit’s rear cover.	the battery compartment in the
		indicated direction.
Setup
Playback	e Put the rear cover back on.
HDMI
	NOTE
Control	•Use R6/AA batteries in this remote control.
	even when the remote control unit is operated close to the unit.
	•Replace the batteries with new ones if the set does not operate
Function	(The supplied batteries are only for verifying operation.)
	following the “q” and “w” marks in the battery compartment.
	• When inserting the batteries, be sure to do so in the proper direction,
Information	•To prevent damage or leakage of battery fluid:
	Do not use a new battery together with an old one.
	Do not use two different types of batteries.
	Do not attempt to charge dry batteries.
	Do not short-circuit, disassemble, heat or dispose of batteries in
Troubleshooting	flames.
	•If the battery fluid should leak, carefully wipe the fluid off the inside
	of the battery compartment and insert new batteries.
	•Remove the batteries from the remote control unit if it will not be in
	use for long periods.
	•Used batteries should be disposed of in accordance with the local
Specifications	regulations regarding battery disposal.

Operating Range of the Remote Control Unit

Point the remote control unit at the remote sensor when operating it.

30° 30°

Approx.23feet/7m

NOTE

The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.

Remote Control Settings (Remote Control Side)

Switches when the DBP-4010UDCI’s remote control operates another DENON BD players in the vicinity.

Set the remote control code simultaneously on the main unit, too. For how to set codes, see GUI menu: “Other Setup” – “Remote Control Setting” – “Remote ID” (vpage 31).

GRemote control code settingH

1: Set the remote control code to “1”.

2: Set the remote control code to “2”.

•If the signal code of the remote control does not match the signal code of the unit, the remote control code set on the unit is shown on the display.

GExampleH

If the code setting on the unit is “DENON 1”, and the setting on the remote control is “2”, “PLAYER 1” is shown on the display.

NOTE

•Match the signal code of the remote control with the signal code of the unit. If the remote control code is different, you cannot operate the DBP-4010UDCI with the remote control.

•Even if you change the remote control code, set GUI menu “Other Setup” – “Remote Control setting” – “Receive Legacy Remocon” (vpage 31) to “Off” when operating the DBP-4010UDCI with a remote control other than DENON’s.