Denon 4010UDCI Connecting the Power Cord, Once Connections are Completed, Turning the Power On, nModem, nRouter, nOthers, Press the unit’s, System Requirement

5. Using BD-LIVE function or updating the software version of DBP-4010UDCI

System Requirement

nInternet Connection by Broadband Circuit

nModem

Device that connects to the broadband circuit and conducts communications on the Internet. A type that is integrated with a router is also available.

nRouter

When using the DBP-4010UDCI, we recommend a router with the following features.

•Built-in DHCP (Dynamic Host Configuration Protocol) server.

Function that automatically assigns an IP address on the LAN.

•Built-in 100BASE-TX switch (built-in switching hub compatible with speeds upwards of 100 Mbps)

nEthernet cable (CAT-5 or greater recommended)

•An Ethernet cable is not included with the DBP-4010UDCI.

•For Ethernet cable, we recommend you use shielded straight cable (normal type).

If you use the flat type or a non-shielded cable, the noise may adversely affect other devices.

For Internet connection, use an ISP (Internet Service Provider). Ask your local dealer for details.

NOTE

•It is necessary to subscribe to an ISP in order to connect to the Internet. If you already have a broadband connection, there is no need to subscribe anew.

•The router you can use varies with the ISP. For more information, contact your ISP or PC dealer.

•DENON assumes no responsibility whatsoever for any communication errors or troubles resulting from customer's network environment or connected devices.

nOthers

•The DBP-4010UDCI can use the DHCP function to automatically set the network.

•With the type of circuit in which network setting is performed manually, when subscribed to a provider, conduct the setting in accordance with “Network Setup” on the GUI menu (vpage 29).

•If you connect the DBP-4010UDCI to a network without a DHCP function, conduct IP address and other settings according to “Network Setup” on the GUI menu (vpage 29).

•The DBP-4010UDCI does not support PPPoE. If you subscribe to a circuit that is set with PPPoE, a PPPoE-compatible router is required.

•When setting manually, check the setting contents with the network administrator.

ENGLISH

Connecting the Power Cord						Getting
Connect the included power cord to the DBP-4010UDCI, and plug it into an AC outlet.
						Started
				To household power		Connections
				outlet (AC 120 V, 60 Hz)
				Power cord
				(included)
						Setup
NOTE						Playback
•Be sure to insert the power plug firmly. Incomplete connection results in noise generation.
Once Connections are Completed						HDMI
						Control
Turning the Power On
						Function
Press the unit’s		or the remote control’s .				Information
The power is turned on, and the power indicator lights green.
“LOADING” appears on the display, and disc information is read.
b The “NO DISC” message is displayed when a disc is not loaded.				(DBP-4010UDCI)	(Remote control
						Troubleshooting
					unit)
On the GUI menu, when “Other Setup” – “Auto Power Mode” – “On” (vpage 31), the following states are
maintained for about 30 minutes, and then the power is turned automatically to standby.
•Disc not loaded						Specifications
•Playback has stopped
•Stopped due to resume function
n When power is switched to standby
Either press	on the unit, or press		on the remote control.

The power indicator lights red.

NOTE

During power standby, a slight amount of power is consumed. To totally cut off the power, remove the power cord from the power outlet.

20