Denon ADV-1000 PCM, DTS, PCM, DTS, PCM, DTS, PCM, DTS, PCM, DTS, PCM, DTS, PCM, DTS, Input mode display, Input signal display, Input mode when playing CD sources

ENGLISH

4	Start playback on the selected component.
	• For operating instructions, refer to the component’s
	manual.
5	Either turn the MASTER VOLUME dial on the main unit or
	use the VOLUME buttons on the remote control unit to
	adjust the volume.
	M.VOLUME -20	The volume level is displayed
		on the display.

	MASTER VOLUME
			VOLUME
		Main unit	Remote control unit

•The volume can be adjusted within the range -60 to 0 to +18 dB. Note that depending on the input signal, surround mode, speaker settings and channel level setting, it may not be possible to adjust the volume up to +18 dB.

Input mode when playing DTS sources

•If DTS-compatible CDs are played in the “PCM” mode, noise is output because DTS playback is not possible.

To play a DTS-compatible source, be sure to set the input mode to “AUTO” or “DTS”.

•Noise may be generated at the beginning of playback and while searching during DTS playback in the AUTO mode. If so, play in the DTS mode.

2To check the currently playing program source, etc. Press the STATUS button.

	FUNCTION	STATUS
STATUS	/ SELECT

Main unit

Remote control unit

To perform this operation on the main unit, press the STATUS button, then turn the FUNCTION/SELECT knob.

The current program source and surround settings are shown on the display each time the button is pressed. (When the function is set to DVD, the information is also displayed on the TV screen.)

Input mode display

Lit

• In the AUTO mode	DIG	AUTO PCM	DTS
	ANA	One of these lights, depending on
		One of these lights, depending on
		the input signal.
• In the DIGITAL PCM mode	DIG	AUTO PCM	DTS
	ANA
• In the DIGITAL DTS mode	DIG	AUTO PCM	DTS
	ANA
• In the ANALOG mode	DIG	AUTO PCM	DTS
• In the ANALOG mode	ANA

Input signal display

• DOLBY DIGITAL	DIG	PCM	DTS
				PRO LOGIC II
		DIGITAL

• DTS	DIG	PCM	DTS	One of these
				lights, depending
		DIGITAL		on the input
				signal.
• PCM	DIG	PCM	DTS

		DIGITAL

•“DIG” lights when digital signals are input properly. If “DIG” is flashing, check whether the connections are proper and whether the input component’s power is on.

Input mode when playing CD sources

•When playing CDs containing recordings of live concerts, etc., in the “AUTO” mode, the sound may be slightly broken at the beginning. If this happens, switch to the “PCM” mode.