Denon ADV-1000 YES NO, movie, music, NOTES:, DEFAULT setting, •DEFAULT setting, When DTS encoded, When DTS encoded, •LFE level setting, Surround parameters (2)

•LFE level setting

LFE 0dB

-10 ...-5 ...0

,/

The LFE level can be adjusted between –10 dB and 0 dB in steps of 1 dB.

•DEFAULT setting

DEFAULT Y/N

YES NO

,/

When “YES” is selected, the settings are reset to their factory default values.

Stop operating buttons once the surround parameter settings have been completed. After several seconds the normal display reappears and the settings are automatically set.

NOTES:

•When “DEFAULT” is selected and the cursor button is pressed (“YES”), “D.COMP.” is automatically set to “OFF” and “LFE” is reset to the default value.

(“D.COMP.” is not valid for DTS source.)

•Signals encoded in Dolby Digital can only be played in the Auto decode (Dolby Digital, Dolby Pro Logic II or Auto stereo), Stereo, Direct or Virtual modes. Other modes do not work when playing Dolby Digital signals.

•DTS signals can only be played in the Auto decode (DTS), Stereo or Direct modes. Other modes do not work when playing DTS signals.

•DTS signals can also be played in the “DTS” input mode. (See page 35.) In this case, decoding and playback are only performed when DTS signals are input.

ENGLISH

Surround parameters (2)

D.COMP. (Dynamic Range Compression):

•This parameter adjusts the dynamic range of the Dolby Digital sound. When listening with the volume turned relatively low, at night for example, set this to the “HI” side to lower the peak of the sound and amplify the quieter sounds, narrowing the dynamic range and making the sound easier to listen to. Set to “OFF” to turn this function off.

OFF LOW MID HI

Dynamic range Wide Narrow

LFE (Low Frequency Effect):

•Program source and adjustment range

1.Dolby Digital: –10 dB to 0 dB

2.DTS Surround: –10 dB to 0 dB

•When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital playback.

•When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback.

•When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to –10 dB for correct DTS playback.

45