Denon AVR-3801 manual Setting the Digital In Assignment, To select the input source

Models: AVR-3801

1 72
Download 72 pages 15.54 Kb
Page 26
Image 26

When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect ALL surround modes. Consider this mode a Master Channel Level adjustment mode.

After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround mode on page 49.

You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, 5/7 CH STEREO, DOLBY/DTS SURROUND, WIDE SCREEN, ROCK ARENA, JAZZ CLUB, VIDEO GAME, MONO MOVIE, and MATRIX.

When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balance of playback levels between each channel for the various selections of “A or B” and “A and B”.

Setting the Digital In Assignment

• This setting assigns the digital input jacks of the AVR-3801 for the different input sources.

1

At the System Setup Menu select “Digital In Assignment”.

 

 

TUNING

BAND

MODE

 

TUNING

2

ENTER

SHIFT

Switch to the Digital Inputs screen.

3

4

Select the digital input jack to be assigned to the input source.

TUNING

 

 

TUNING

To select the input source

 

 

 

 

BAND

MODE

 

 

To select the digital input jack

BAND

MODE

Select “OFF” for input sources for which no digital input jacks are used.

 

 

 

 

 

 

TUNING

 

 

TUNING

 

If “Yes” is selected for “Default”, the settings are automatically reset to the default values.

ENTER

 

Enter the setting.

 

 

 

 

The System Setup Menu reappears.

SHIFT

NOTES:

The OPTICAL 3 jacks on the AVR-3801’s rear panel are equipped with an optical digital output jack for recording digital signals on a CD recorder, MD recorder or other digital recorder. Use this for digital recording between a digital audio source (stereo - 2 channel) and a digital audio recorder.

Do not connect the output of the component connected to the OPTICAL 3 OUT jack on the AVR-3801’s rear panel to any jack other than the OPTICAL 3 IN jack.

“PHONO” and “TUNER” cannot be selected on the Digital In Assignment screen.

25

Page 26
Image 26
Denon AVR-3801 manual Setting the Digital In Assignment, To select the input source, To select the digital input jack