Denon AVR-3801 manual Input mode display, Example Stereo, Input signal display

• Selecting the PCM mode

Input mode display

Press the PCM button to switch to the PCM signal input.

PCM

(Main unit)

•Selecting the DTS mode

Press the DTS button to switch to the DTS signal input.

DTS

		(Main unit)
3	Select the play mode.
	Example: Stereo
	SURROUND	SELECT
	MODE

STEREO

(Main unit) (Remote control unit)

To select the surround mode while adjusting the surround parameters, channel volume or tone control, press the surround mode button then operate the selector.

SURROUND

MODE

• In the AUTO mode

INPUT

AUTO PCMDTS

• In the DIGITAL PCM mode

INPUT

AUTO PCMDTS

• In the DIGITAL DTS mode

INPUT

AUTO PCMDTS

• In the ANALOG mode

INPUT

AUTO PCMDTS

Input signal display

• DOLBY DIGITAL

SIGNAL

LOCK DIGITAL

• DTS

SIGNAL

LOCK DIGITAL

• PCM

SIGNAL

LOCK DIGITAL

One of these lights, depending on the input signal.

DIGITAL ANALOG

DIGITAL

DIGITAL

ANALOG

(Main unit)

4	Start playback on the selected component.
	• For operating instructions, refer to the component’s
	manual.
5	Adjust the volume.
			VOLUME
		MASTER VOLUME	+
			-
	The volume level is
	displayed on the	(Main unit)	(Remote control unit)
	master volume level
	display.

The volume can be adjusted within the range of –60 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 23 or pages 49 and 50, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is “18 dB — (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “DTS”.

The LOCK LED lights when digital signals are being input properly. If the LED does not light, check whether the digital input component setup (page 25) and connections are correct and whether the component’s power is turned on.

NOTE:

•The digital input indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard.

43